Roof Safety Recertification, Height Safety Recertification

Height Safety Systems need to be inspected and maintained periodically.

Previously compliant height safety systems can be rendered unsafe/non-complaint for many reasons:

  • Unsafe Access - Roof RecertificationStructural Changes to building/vehicles (planned or otherwise)
  • Compromised building material integrity due to:
    • Weather events
    • Insects
    • Rust
    • Stress or vibration weakening
  • Damaged Height Safety Equipment fixtures due to misuse or collateral damage
  • Poor Quality Installation 

 

Ambulance Height SafetyDon’t Leave your system recertification until its too late.

It is critical to ensure that Height Safety Systems are regularly inspected and maintained to ensure a safe working environment and compliance with Australian legislation.

Australian Standards requires ALL height safety systems to be inspected regularly due to the high risk nature of working at heights.

 

Let us book your recertification now

Fill out the form below or call 1300 884 978

Your Name (required)

Your Email (required)

Your Phone Number (required)

Your Message


Height Safety Engineers Call Us


Recertification Package ExtensionsRoof Safety Plan

Extend your recertification package with our upgrade options

  • Whole site plans setup whilst conducting annual inspection service
  • Plan will show all access points, anchor points and/or static lines
  • Plan presented in a “marked-up” satellite format

PPE Inspection - Roof Safety Inspection

  • All Height Safety PPE inspected whilst on site performing Annual Roof Access Inspection
  • All Height Safety PPE Documented on Equipment Inspection Register
  • All inspections as per AS/NZS 1891.4 Appendix C & D (Legislative Inspection interval for PPE = 6 months)

Anchor Tagging - Roof Safety Inspection

  • Anchors individually tagged & identified for increased peace of mind, and increased clarification and accuracy of record keeping.
  • First 10 Anchors tagged – NO CHARGE.
  • No Charge made for “out of service” labels.

 

Frequently Asked Questions

Why should I have my roof access system certified?

WHS legislation and Australian Standards require Fall Arrest Equipment to be inspected & certified by a suitably competent person prior to first use and then on a regular basis. This inspection and certification is to ensure the equipment is correctly installed in accordance with manufacturer’s instructions. It is also important to ensure the structure to which an anchor is attached is adequate for the imposed loads, & has not been modified and/or deteriorated in any way that the structural adequacy could be affected.

How often should I have this done?

Australian Standards require that inspection intervals be in accordance with the manufacturer’s recommendations. As a general rule these intervals are as follows:

  • Fall Arrest Anchors – Annually
  • Horizontal Lifelines – Annually

How can HSE help you?

All inspections are carried out in accordance with AS/NZS 1891-2000 Part 4 Section 9. In the case of fixed Anchorages and Static lines covered by Part 9-3-3, the inspection /recertification includes, but is not limited to the following:

  • The inspection interval for anchorages shall be every 12 months.
  • Anchorages shall be visually inspected for signs of deterioration which might make them unserviceable together with any other requirements contained in manufacturer’s instructions.
  • The parent structure shall also be visually inspected for modifications or deterioration which might lead to loss of anchorages. Anchors such as friction or glued in anchorages shall be proof tested in accordance with Clause 3.1.2 (g) as part of each inspection

Height Safety Engineers offers this recertification service to our clients based on a very reasonable rate schedule. We endeavor to carry out all works in the most economical manner possible to ensure compliance within all legislative guidelines. We provide quotations on request based on individual site requirements.

Please do not hesitate to contact us should you have any further questions.

We look forward to serving your current and future requirements.